Zantac Research Today is a free monthly online journal that collates and summarizes the latest research about Zantac, including details on ranitidine, side-effects, allergic reactions, information.

Physical characterization and stability of amorphous indomethacin and ranitidine hydrochloride binary systems prepared by mechanical activation.

Chieng N, Aaltonen J, Saville D, Rades T

School of Pharmacy, University of Otago, Dunedin, New Zealand.

Co-milling of gamma-indomethacin and ranitidine hydrochloride form 2 at various weight ratios (1:2, 1:1 and 2:1) was investigated with a particular interest in the physicochemical properties and the stability of the milled mixed amorphous form. Co-milling was carried out using an oscillatory ball mill for various periods of time up to 60min in a cold room (4 degrees C). The maximum temperature of the solid material was 42 degrees C during co-milling in a cold room. Results showed that both indomethacin and ranitidine hydrochloride were fully converted into the amorphous state after 60min of co-milling. In contrast individually milled drugs remained partially crystalline after co-milling under the same conditions. During co-milling, the XRPD characteristic peaks of indomethacin were found to decrease faster than those of ranitidine hydrochloride. DSC results were in agreement with XRPD, and T(g)s of the fully converted amorphous mixtures of 29.3, 32.5 and 34.3 degrees C were measured for the 1:2, 1:1 and 2:1 mixtures, respectively. These T(g) values were in good agreement with the predicted T(g)s of the mixtures using the Gordon-Taylor equation. DRIFTS spectra of the co-milled amorphous samples showed peaks at 1610, 1679 and 1723cm(-1), that were not present in the individually milled samples and that are indicative of an interaction at the carboxylic acid carbonyl (HO-CO) and benzonyl amide (NCO) of the indomethacin molecule with the aci-nitro (CN) of ranitidine hydrochloride. Upon 30 days of storage, the 1:2 mixtures were found to crystallize; however, the amorphous 2:1 and 1:1 mixtures were stable when milled for 60min and stored at 4 degrees C (for the 2:1 mixture) and at 4 and 25 degrees C (for the 1:1 mixture), respectively. Although XRPD, DSC and DRIFTS suggested an interaction between the two drugs, co-crystal formation was not observed between indomethacin and ranitidine hydrochloride.

Published 22 July 2008 in Eur J Pharm Biopharm.
Full-text of this article is available online (may require subscription).

© 2004-2008 Zantac Research Today. All Rights Reserved.